| Article #218 - Falulty twinax cable or display station |
|---|
| Updated:02-17-2006 - Views: 481 |
| I think I may have a faulty cable or display station. What can I do to test this?
To test the cable or line, enter twinax monitor mode on an I-O terminal by holding the spacebar down during boot up. Once in the restricted portion of the setup screen press the letter (T). Displayed on the screen is a "map" of the devices on this single twinax cable. A counter will increment as devices talk back and forth with the AS/400. If a device address doesn't respond to a poll or reports an error, a cable, pigtail, or device is suspect. (Remember, the display being used for the test will not respond to a poll). To exit and return to your session press (enter). |
|
Use the form below to submit a comment on this article for inclusion into the knowledgebase. End-users are welcome to submit articles relating to any category in the knowledgebase. Submit a comment in response to the knowledgebase article. Please keep the response professional, the content may be modified by the Knowledgebase Administrator. Before posting the comment will be reviewed and may be edited for brevity, structure and content. |